The drywall screw heading die manufacturer tells you that you must first understand a basic problem, what is the cost of mold manufacturing. Mold manufacturing cost is the sum of mold material cost plus machining fees and taxes. Of course, there are labor costs. But it can be considered that the labor cost has been included in the processing technology cost. Of course, there are also some industrial design costs. So how to save mold manufacturing cost? Let's take a look below.

1. Whether the product design is reasonable and how to develop it has become an important factor affecting the cost of mold manufacturing. If the product structure design is unreasonable, it is a very bad situation for the mold enterprise. Drywall screw heading die manufacturers tell you that it is the direction of mold manufacturers to make the designed products as suitable for mold engineering as possible without increasing the difficulty and cost of mold manufacturing.
2. Product design changes the mold. Mold manufacturers often encounter this situation. The drywall screw heading die manufacturer tells you that in a project, the mold has just been designed, the mold base has been ordered, and the customer's design change notification will come. If the change is relatively small, it will not affect the overall structure of the mold. Sometimes there are changes, the shape of the product made by the mold changes, and even the mold frame needs to be reordered. Costs will increase significantly. Therefore, design changes should be as few as possible so as not to change too much.
3. Whether the mold design is appropriate, and whether the mold design is reasonable and feasible. The drywall screw heading die manufacturer tells you that there are various simulation methods, such as mold manufacturing process analysis, mold structure dynamic analysis, 3D comparative analysis of trial products and design products, etc., which can prevent unreasonable mold design and prevent costs from increasing continuously. .
4. Control the number of mold manufacturing tests. Many mold makers calculate mold manufacturing costs based on the number of days it takes to send the mold to the customer after receiving the order. The drywall screw heading die manufacturer tells you that if the mold cannot be shipped after multiple inspections, in addition to the fines stipulated in the contract, the longer the mold stays in the factory, the higher the processing fee. Of course, the cost of mold trial is relatively high.
The above is the introduction of the drywall screw heading die manufacturer to tell you how to control the cost of mold manufacturing.