The manufacturer of drywall screw flat thread rolling die tells you that friends who are engaged in wire drawing production will naturally like the industry of wire drawing die equipment very much. Needless to say, in terms of mechanical equipment, I believe everyone will cherish it very much. Today, I will share with you how to use and maintain the drawing die equipment.

1. The installation foundation of the wire drawing die equipment needs to be very stable to avoid vibration;
2. The drywall screw flat thread rolling die manufacturer tells you that during the installation process, through debugging, the pulling axis of the wire must be symmetrical to the center line of the die hole, so that the stress on the wire and the drawing die is even.
3. Avoid frequently starting and stopping the drawing die equipment during the drawing process, because the friction force caused by the tensile stress at the beginning of drawing is much larger than that in the normal drawing process, which will increase the degree of wear of the die.
During the long-term use of the wire drawing die equipment, the die wall will be strongly rubbed and scrubbed by the wire, which will inevitably cause wear. The more common one is an annular groove in the work area where the wire enters. The manufacturer of drywall screw flat thread rolling die tells you that the appearance of the annular groove of the wire drawing die has aggravated the wear of the die hole, because the small particles of the core material peeled off due to the loosening of the annular groove are brought into the working area and the sizing area.
The die hole of the wire drawing die equipment uses the metal wire as the abrasive and enters the die hole. The thread of the mold hole increases the wear of the mold hole like a grinding needle. If it is not replaced in time, the annular groove will continue to accelerate and expand, making maintenance more difficult, and even cracks may appear in the deeper part of the annular groove, which will cause the mold to break and be scrapped.
Therefore, it is very beneficial to strengthen daily maintenance and frequently overhaul wire drawing die equipment. Once the mold is slightly worn, timely polishing only takes a short time to restore the mold to its original polished state, and the hole size of the mold will not change significantly.
To sum up, it is necessary to avoid the dimensional fluctuation of the wire drawing die equipment during the wire drawing production process. The drywall screw flat thread rolling die manufacturer tells you that in addition to selecting the appropriate mold material, designing a reasonable hole size, improving the manufacturing level of the wire drawing die and making the surface finish of the die hole meet the technical requirements, it is also necessary to determine a reasonable pass rate. Pay attention to the daily maintenance of the wire drawing die equipment during use, clean it frequently, and ensure that it has good lubrication during the drawing process.